Check Engine Light
My check engine light came on the other day but it was on and off my whole way home. I assumed it was oil but my oil is good. I found how to check codes, but it didn't quite go as expected.
The instruction said to hold RESET and turn the ignition on until DIAG appears on the screen. But as soon as I turn the ignition on, I am getting "22" on the screen. If I hold SELECT and RESET together while turning the ignition on, I'll get to the DIAG screen but there are no CEL codes, just the engine diagnostics. If I continue to hold RESET and press/hold SELECT after the code turns on, it appears to have reset the CEL.
So I am assuming the CEL is code 22 which is the air temp sensor and I went ahead and ordered the sensor, but am hoping for some clarification that this is correct.
The only reason I can think of as to why the instructions are different is because of my Digital Guard Dog ignition. I don't have an ignition switch & kill switch anymore. The kill switch is rewired as the ignition switch, so I can't turn the ignition on with the kill switch off. Not sure if that makes a difference...
My bike is a 2012 Stryker