Yamaha Star Stryker banner
1 - 1 of 1 Posts

· Registered
Joined
·
14 Posts
You could bond some rubber strip material to the frame to increase the diameter and clamp to it.

Or check out your local hardware store for the rolls of cut to length rubber tubing. Find one that will have a similar ID to the OD of the frame. Buy a foot and cut as necessary to fit and clamp it on.

Or if you have access to a 3D printer make 2 halves of a tube that could wrap around the frame. Make it slightly wider than the clamp width and add and add raised edge lips to keep the clamp in place. Use a little adhesive to bond the tube halves in place on the frame.

I'd try to bond a material like rubber to the frame and clamp to that to help keep the clamp from rotating.
 
1 - 1 of 1 Posts
Top