Yamaha Star Stryker banner
1 - 4 of 4 Posts

· Registered
2012 stryker
Joined
·
114 Posts
Discussion Starter · #1 ·
Hey everybody. Merry Christmas to everyone. Just wanted to give you guys a peek at my low and mean radiator cover. It's just about ready to go. I added a couple of pin stripes and decal , and then found a nice piece of aluminum mesh from Amazon to finish it off . I think we're done!
Light Black Carnivore Grey Cat
 

· Registered
2012 stryker
Joined
·
114 Posts
Discussion Starter · #4 ·
Merry Christmas!
Nice job. How did you attach the mesh?
I kinda molded it by bending the edges so it was a good fit , then I used gorilla glue in several spots and allowed it to dry overnight. The next morning I applied some more, making sure that the spots I first did were holding in place. . Later on , I went back along the inside edges and ran I nice bead of silicone sealant around it . This way, the silicone will ( hopefully) lessen any vibrations when riding. - I think it turned out good and solid . The decal I put on it has a small center screw ( predrilled) and the back of the decal came prepared with 3m sticky back adhesive, so it's on good too. I'll follow up with a photo after the install. 😎
 
1 - 4 of 4 Posts
Top