[Blacked out 2011]

Just got my arlen ness deep cut rear pegs and they aren't staying up on the locking position. Something isn't right with this bearing and plate that it slides on to lock in the upright position. Any advice is much appreciated!!

 

[SmokenJoe]

Got any pictures of parts and mounting?

 

[Texastryker]

Rub some viagra on them and wait about hour should work.

 

[SmokenJoe]

They stay up because of the washers that hit the mount. Try adding another washer.

 

[Blacked out 2011]

I figured it out...you would think that mounting plate that the ball bearing rides on would match the contour of the peg...well it doesn't. It needed to be flipped around so that when you lift the peg up the square end grabs and lets the bearing swing up to the other he position. Sorry no pics il post later after work.

 

[SmokenJoe]

Glad you got it figured out. Ness makes some good products. I have the deep cut front pegs and grips.

 

[stretch_o]

Yeah, I just put a set on. Took me a minute to figure the latch plate out also.

Sent from my SAMSUNG-SGH-I337 using Tapatalk 4