[kakarot]

So yesterday my sidewalk install went bad... My 40 minute swap turned into a 3 hour challenge....

However, I popped off the V&H big radius... Popped on the cobra swepts.... Which is pretty much 2 bolts and 2 nuts that were already on the bike...

Packaged the pipes and o2 sensor and shipped them to a board bro on here. Question is, is there specific hardware he will require? Or will the stock nut/bolts cover him?

I already emailed V&H to see I they have a mounting kit... But going by memory, not much is required, as the pipes are already installed.

Thx

Hmm, mounting bracket for sure.....

 

[Skwerlee]

yes there will be some hardware he'll need. The main thing is the spacer and extended bolts that move the peg/rear brake lever out for clearance.

Click on this link to view the instruction sheet PDF that outlines everything needed.

http://www.vanceandhines.com/store/metric/yamaha/18529

 

[kakarot]

yes there will be some hardware he'll need. The main thing is the spacer and extended bolts that move the peg/rear brake lever out for clearance.

Click on this link to view the instruction sheet PDF that outlines everything needed.

http://www.vanceandhines.com/store/metric/yamaha/18529

Thx

I emailed V&H, I hope and assume they sell the kit? Might be easier then me shipping anything from Canada!