Blaster-X

818 Views 3 Replies 4 Participants Last post by JRRKAR, Sep 7, 2013

RustyJake

Discussion Starter · Sep 7, 2013

For those running the Blaster-X tail light, are you running any relays to assist with the blink speed?
Those running just a tail light assembly? Yes/No
Running front LED's as well?

If you are running a relay, what seems to be the preference? The ELFR-1 seems to fit the bill for simplicity, but does it effect the self cancelling feature on the signals on the bike?
thanks in advance, just trying to cover all the basis before placing an order.

Save

1 - 1 of 4 Posts

kraaazymike

· #3 · Sep 7, 2013

I originally used resistors out the back but then I switched to an electronic relay (I forget which one). I didn't care about losing the auto cancel but I did notice the rate is still a touch fast.

I had this setup with both incandescent bulbs up front and LED's upfront. No difference.

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month