Blinker Problem

So, quick run down on what I just did. I replaced my front and rear turn signals and a new head light. Since I didn't want to cut a hole in the back of this head light, I took the tank off and cut 8 inches of the wiring harness off so that all the wires are tucked in under the gas tank, giving it a cleaner look. Now, as I did that, I wired everything up to make sure that they all worked and they all worked properly. So I then cut each wire independently and rewired and soldered them. By doing them one at a time I was pretty sure that I wouldn't get any wires crossed up. So, now that they are wired I checked again and now all 4 blinkers blink together, as if in emergency blinkers. Is there such a thing with bikes or what is causing them to blink all together and how do I get them back to normal? Any and all help is greatly appreciated!