Yamaha Star Stryker banner

Blinker Problem

2102 Views 8 Replies 8 Participants Last post by  usmarinedelta
So, quick run down on what I just did. I replaced my front and rear turn signals and a new head light. Since I didn't want to cut a hole in the back of this head light, I took the tank off and cut 8 inches of the wiring harness off so that all the wires are tucked in under the gas tank, giving it a cleaner look. Now, as I did that, I wired everything up to make sure that they all worked and they all worked properly. So I then cut each wire independently and rewired and soldered them. By doing them one at a time I was pretty sure that I wouldn't get any wires crossed up. So, now that they are wired I checked again and now all 4 blinkers blink together, as if in emergency blinkers. Is there such a thing with bikes or what is causing them to blink all together and how do I get them back to normal? Any and all help is greatly appreciated!
1 - 1 of 9 Posts
As vague as it sounds check your grounds you may have then tied two together causing all four to flash when putting your signal on. also check your input to each turn signal to make sure they are not tied together.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.