[chance]

Anyone know how to remove the chrome cover that is covering the ignition? I've pulled on it with a little force, but still not sure if its held down by bolts or just double sided tape. Any input??

 

[kraaazymike]

There's two screws behind it. Move the handle bars from side to side to get to them.

 

[chance]

Thanks Mike

 

[kraaazymike]

Np. If you haven't looked yet, they're metallic colored phillips screws.

 

[chance]

Found them, plasti'd it and reinstalled. Thanks again bro!

 

[jordanbmsu]

Looks good, I did the same to my bike.

 

[klarowe]

I opted to just take mine off. I had it plasti-dipped for a while, but It just looks so much cleaner completely off... lol

 

[mikoloe]

ok, here is a stupid question...

Where did you relocate this to?

 

[kraaazymike]

^he converted to keyless. The funny part is that he forgot he needs a key to open the gas tank. I'll let him tell you about the condom.

 

[klarowe]

LMAO. Yes, I have a Digital Guard Dawg keyless ignition module so the factory key is non-existent. However, what I overlooked was the fact that a key is needed for the gas tank. Since my leather jacket doesn't have any zippered pockets, I had my keys in my jeans which were underneath my full leather pants. So yea... I looked like a fool at the pump having to basically strip down just to get my key out.

Well that brought up a thread on here asking about a keyless tank cap. Well that turned into keeping a key in my wallet near my card for getting gas... and that turned into a whole discussion about condoms.... lol.

 

[chance]

Hahaha awesome.