Yamaha Star Stryker banner

Cobra FI2000r settings

7685 Views 6 Replies 5 Participants Last post by  Blekaxe
Anyone else out there using the Cobra FI2000R with the Cobra Powerflo intake? Just curious what settings you are using? are they close to the settings in the manual that came with the fuel programmer?
1 - 3 of 7 Posts
Do you have exhaust as well or just a slip on? I have the slipon exhaust and still get a little decel popping haven't had the chance to run it 1 up since install. Current settings are 2.5, 5, & 3! Think I am going to adjust the 1st one up to 3 see if that will alleviate decal popping.

Man does intake really sucks in the air you can hear it pulling in!
I don,t think they mean half turn I think they mean half a mark like from 2.0 to 2.5!
1 - 3 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.