[nakoa01]

Guys I am trying to install this thing but I do not see where the injectors are ( I am a novice). What I do see is a bunch of plugs and harnesses that all seem to look alike. Does anybody have any pictures? I read the GMAN BULLY review, but the pics are no longer available. Thanks,

Kirby

 

[BOOLSHOT]

Did you lift the tank at all? They are under the tank. I believe they are grey if I remember correctly ( could be wrong on color). Look at the plugs on the EJK, and look for the similar plugs.

Sent on the run from Tapatalk..

 

[Duff]

They should be the only wire's going to the head's other than the spark plug wire's. You will be able to see them from the opposite side of the engine from the breather. They are between the cylinder's by the intake manifold.

 

[nakoa01]

Think I found them. I am not so mechanicly inclined but I kept studying the EJK installation instructions. Hooked it all up and got the running green lights then the one single green blinking. Seems like all is well. Not been for the test ride yet.

 

[nakoa01]

Forgot to unplug the O2 sensor..I have no idea where that is at. Any help?

 

[BOOLSHOT]

The plug is under the panel on the right side. You can see the o2 sticking out of the exhaust just behind the motor.

Sent on the run from Tapatalk..

 

[thibbits]

Just in case you don't already know. The black plastic pin that is holding the side plate on should have a small round section in the middle. You have to push that thru to remove the pin (don't know the term for it).

 

[nakoa01]

thibbits...ur a life saver dude. Like I said..not mechanically inclined...would have never figured that out. THanks...test ride time. Kirby