Yamaha Star Stryker banner

1 - 20 of 58 Posts

·
Registered
Joined
·
967 Posts
Don't think the bottom would last to long. To thin a area that is to low. Your either going to crack or break off the bottom.
 

·
Registered
Joined
·
523 Posts
Discussion Starter · #11 ·
Thanks for the feedback! Wlfpak & My Life, I think you're right. I'll post another render - I don't want it to crack on the road. Rear fender on my avatar is a Photoshop render too - measure twice, cut once, right? Here's a full-size...

As for the headlight, it's from demonscycles.com - I like the Victory light, but this one's a bit less coin, and I like the look. Gonna take the saved cash and go HD LED light, eventually. Next post - modified trim render on the bottom half of the front fender...
 

Attachments

·
Registered
Joined
·
523 Posts
Discussion Starter · #17 ·
Shanks Schimbo, again, I think you're right. Re-did the back - see my images page for before/afters on the back fender, rear view and side views. Also looking at a flush LED in the rear. Any votes on the integrated tail LED design? (see my page again for all of them) THIS FORUM KICKS @$$! You guys rule.
 

Attachments

1 - 20 of 58 Posts
Top