Yamaha Star Stryker banner
1 - 18 of 18 Posts

· Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
Just got my 2011 Stryker yesterday. Took her out today and put 100 miles on her. I will definitely be getting forward controls. A 32 inseam and mustang seat make me feel too close to the pegs. This means that I will have to take the engine guard off but hey...now I'll have room for that L&M chin spoiler!

Its a great forum with lots of info. I hope to be able to contribute someday.

 

· Registered
Joined
·
569 Posts
Welcome from the Berkshire Mts of Massachusetts.
 

· Registered
Joined
·
749 Posts
welcome from maine
 

· Registered
Joined
·
137 Posts
Just got my 2011 Stryker yesterday. Took her out today and put 100 miles on her. I will definitely be getting forward controls. A 32 inseam and mustang seat make me feel too close to the pegs. This means that I will have to take the engine guard off but hey...now I'll have room for that L&M chin spoiler!

Its a great forum with lots of info. I hope to be able to contribute someday.
I put the forward controls on a friends bike that had the engine gaurd on it . Used the engine gaurd bracket in place of the spacers that came with the kit it worked great . Just don't put the washers on the head side of the bolt toward the pegs . If the washer is there the head of the bolt is againts the frame .
 
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top