Yamaha Star Stryker banner

How to properly tie-down a Stryker?

3279 Views 10 Replies 6 Participants Last post by  klarowe
After a long wait, I finally got a chance to pick up an enclosed trailer. A good buddy of mine and I both went halves and found a nice enclosed 6 x 12 a couple hours away. We went for a drive and it ended up being a little dirty, but in overall great condition for the price ($1100)

We went out and picked up 2 harbor freight wheel chocks with the full craddle (hold the bike up to easily be able to strap it down). I actually have to modify mine slightly because the Stryker front wheel is too big and the cradle doesn't allow it to sit on the ground.

Anyways, what is the best way to strap down the Stryker. With my R6, I used a canyon dancer handlebar tie-down and strapped the front down until the front forks were fully compressed. Some said this was the best way, but to me it seemed like it was putting a lot of stress on the fork seals. I would prefer a way to strap it down that didn't put stress on the forks / seals.

So, how do you properly tie down a Stryker???
1 - 1 of 11 Posts
StrykenShane said:
I also strap mine to the handlebars, when my buddy and i tow ours we typically back one bike in put 2 straps on both front and rear, never had had a problem
Very good idea, Shane. I use the Cycle-cinch strap kit....attaches to handlebars.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.