[sledhead44]

Is there a way to adjust the Shifter Lever? My boot gets stuck between the footpeg and the shifter sometimes, so I was wondering if anyone was able to raise the shifter lever to give a little more room.

 

[strykenshane]

Yeah, there are 2 nuts, one at each end of the linkage, you can loosen those nuts and adjust the linkage, be sure to tighten them back up, I had the same problem

 

[mikey76]

Just a heads up in case you dont know, use a wrench to hold the swivel on the end of the linkage when loosening and tightening. Someone else on this forum snapped the linkage because they didnt hold the swivels.

 

[strykenshane]

Oops, forgot all about that

 

[sledhead44]

Thanks guys! I'll try it later today.

 

[ROADKILL]

Just a heads up in case you dont know, use a wrench to hold the swivel on the end of the linkage when loosening and tightening. Someone else on this forum snapped the linkage because they didnt hold the swivels.

The front is left hand thread and the rear is right hand...there should be a a place to put an open end wrench on the shift linkage to hold it when you loosen the nuts

 

[sledhead44]

Just wanted to say thanks again for the info and tips! I got it all adusted without any trouble. I love this site!

 

[mikey76]

Just wanted to say thanks again for the info and tips! I got it all adusted without any trouble. I love this site!

You are welcome

 

[IDStryker]

Just a heads up in case you dont know, use a wrench to hold the swivel on the end of the linkage when loosening and tightening. Someone else on this forum snapped the linkage because they didnt hold the swivels.

Good to know. I haven't used one to hold it in the past, but will start now!

 

[gunny]

Just a heads up in case you dont know, use a wrench to hold the swivel on the end of the linkage when loosening and tightening. Someone else on this forum snapped the linkage because they didnt hold the swivels.

Great tip. Thanks for the heads up!