[1304cc]

A question for all the ISO grip users...

Is it possible to screw the stock Yamaha bar end weight back on after installing ISO grips, rather than using the caps that come from Kuryakyn? I just like the finished look of the stock end weights rather than the hex screws.

Thanks for your help.

 

[Silkentek]

A question for all the ISO grip users...

Is it possible to screw the stock Yamaha bar end weight back on after installing ISO grips, rather than using the caps that come from Kuryakyn? I just like the finished look of the stock end weights rather than the hex screws.

Thanks for your help.

I don't think so, I just put iso grips on my bike and the kuryakyn ends are not open like the yamaha stock grips. You would have to cut out part of the end of the iso grip.

 

[11Stryker]

Sounds like something that could be done with a little lathe work though.

 

[1304cc]

Thanks folks.
I'll pick em up and see if we can't modify with a hacksaw and grinder.

 

[11Stryker]

Where theres a will- theres a way. Anyone seen Will?