Since the other thread has now reached 17 pages, I decided to create a new one to help clean things up a bit for future orders. If you would like to read reviews, you can visit the old thread here:
http://www.yamahastarstryker.com/9-vendor-board/28681-bar-risers-now-available-17.html
Pricing is as follows:
Plain steel: $160 / set shipped (lower 48)
Stainless steel: $180 / set shipped (lower 48)
Powdercoated steel (any color): $200 / set shipped (lower 48)
*All Active Duty Military as well as Veterans receive a 20% discount*
Everything you need will be included (including hardware). Installation is just a few 'quick' steps:
1. Remove the bars
2. Thread the spacers onto the bars.*
3. Insert bars into upper triple tree.**
4. Bolt through bottom of triple tree with supplied bolt / washer.*
5. Re-route cables as needed for proper clearance.
* Blue / Medium strength loctime is recommended but not required (not included). Some sort of lubrication is required for stainless steel to prevent gauling.
** These are made to a very close tolerance. Some minor sand paper work may be required for perfect fitment.
If my calculations are correct, these should give you a rise of approximately 1.6" and a pull back of 1.2". It doesn't seem like much, but feels like a lot more.
These are all made to order so lead time is approximately 4-5 weeks.
*Expediting is possible (typically 1-2 weeks). There is a 50% expediting fee on all expedited orders.
PM me for payment information or via email at klarowe (at) kkdgarage (dot) com.
Pics:
Adrenaline Revolution:

Klarowe:





http://www.yamahastarstryker.com/9-vendor-board/28681-bar-risers-now-available-17.html
Pricing is as follows:
Plain steel: $160 / set shipped (lower 48)
Stainless steel: $180 / set shipped (lower 48)
Powdercoated steel (any color): $200 / set shipped (lower 48)
*All Active Duty Military as well as Veterans receive a 20% discount*
Everything you need will be included (including hardware). Installation is just a few 'quick' steps:
1. Remove the bars
2. Thread the spacers onto the bars.*
3. Insert bars into upper triple tree.**
4. Bolt through bottom of triple tree with supplied bolt / washer.*
5. Re-route cables as needed for proper clearance.
* Blue / Medium strength loctime is recommended but not required (not included). Some sort of lubrication is required for stainless steel to prevent gauling.
** These are made to a very close tolerance. Some minor sand paper work may be required for perfect fitment.
If my calculations are correct, these should give you a rise of approximately 1.6" and a pull back of 1.2". It doesn't seem like much, but feels like a lot more.
These are all made to order so lead time is approximately 4-5 weeks.
*Expediting is possible (typically 1-2 weeks). There is a 50% expediting fee on all expedited orders.
PM me for payment information or via email at klarowe (at) kkdgarage (dot) com.
Pics:
Adrenaline Revolution:

Klarowe:




