[K9Stryker]

Does anyone have this or tried them? Comes with or without license plate adapter. Price without is $99.

 

[wes]

To thin for my personal taste. Can't put a "it looks so clean and cool" factor on safety...

 

[disgruntled0311]

To thin for my personal taste. Can't put a "it looks so clean and cool" factor on safety...

+1....

Check out BlasterX if you haven't already.

 

[K9Stryker]

To thin for my personal taste. Can't put a "it looks so clean and cool" factor on safety...

+1....

Check out BlasterX if you haven't already.

That a member or site?

 

[Visionary]

Does anyone have this or tried them? Comes with or without license plate adapter. Price without is $99.

I saw this sometime ago and posted on it, someone pointed out the gap and square structure of the lights. Once I looked closer and saw it myself I was glad I went with the chromeglow setup http://www.chromeglow.com/catalog.asp?prodid=651396&showprevnext=1 . Alot of people are very surprised at the brightness of them plus with a RTB grabs peoples attention.

 

[K9Stryker]

I got one a 10" from radiantz and its to short, plus I don't know how flexible the chromeglow is but the one I got doesn't bend that good. And now I'm really not wanting to drill a hole in my fender to run the wires

 

[Visionary]

I got one a 10" from radiantz and its to short, plus I don't know how flexible the chromeglow is but the one I got doesn't bend that good. And now I'm really not wanting to drill a hole in my fender to run the wires

I have a nine inch, I used a blow dryer to heat it up. It has 3m tape on it so I heated it up and used 3 small plastic clamps to hold it to the fender while it cooled so it wouldn't pull away when it cooled. So far no problems and get a lot of compliments. I did add some single led lights which act as screws in the license plate and wired each side to it's perspective turn signal so they flash when turning also.

 

[K9Stryker]

I got one a 10" from radiantz and its to short, plus I don't know how flexible the chromeglow is but the one I got doesn't bend that good. And now I'm really not wanting to drill a hole in my fender to run the wires

I have a nine inch, I used a blow dryer to heat it up. It has 3m tape on it so I heated it up and used 3 small plastic clamps to hold it to the fender while it cooled so it wouldn't pull away when it cooled. So far no problems and get a lot of compliments. I did add some single led lights which act as screws in the license plate and wired each side to it's perspective turn signal so they flash when turning also.

Guess I'll have to go get some clamps and some more 3m tape and see what i can do.

 

[disgruntled0311]

That a member or site?

Sorry. The BlasterX is a product offered at customled.com.

 

[SmokenJoe]

That a member or site?

Sorry. The BlasterX is a product offered at customled.com.

http://www.customled.com/products/integrators/Stryker_tail_light/stryker_tail_light.htm

 

[Skwerlee]

+1 on CustomLED

 

[mikoloe]

skwerlee what light did you use for your license plate?