Yamaha Star Stryker banner

license's without tire removal

5682 Views 17 Replies 9 Participants Last post by  zona
Didn't want to take the axle off to install the license plate or even cut a notch in the holder. So I took a 1/2" tap and threaded it into the axle nut about 1" into it. Bought 1/2" lock washer, and regular washer. 1/2" bolt length 1", and thread lock. And there it is. The pics were to large that I took with my phone to add to this post so I just added it on the main gallery called ( threaded plate holder)
1 - 1 of 18 Posts
That's pretty trick looking and well executed....but I think removing that much material from such a crustal component as the axle nut is a bad idea. If the axle nut breaks while at speed you could be in some serious danger. Best of luck
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.