[secretsquirl00]

Does anyone have a better decription on how to install the Ait Intake Adapter. In particular, which was does the part that attaches to the motor go. It comes packaged fitting together but the instructions show it attaching looking like the side with the figure 8 groove pointing out. In the pictures on the website, one shows it facing out the other shows it facing in. The hose looks like it would attach easily if the side with the grooves faces the motor. If that sides faces out how does the hose attach?

 

[Natedog]

The smaller piece that fits inside the larger piece is what attaches to the bike. The side with the grooves for the o-rings is the side that makes contact with the bike. The smooth side fits into the larger (outer cover).

This is not an easy bolt-on installation. I had to make numerous adjustments and modifications to get mine to work. Fortunately once its on, there's little reason to ever remove it.

Hope that helps

 

[secretsquirl00]

Ok, that is what I thought, it is how it came when it shipped and it makes much more sense for the O rings to contact the bike. But when you look at the picture in the directions and on the second picture on the low and mean website it looks like it faces out. I am going to try and intall it this week. Thanks for the help