Low and Mean Air Intake Adapter

1724 Views 2 Replies 2 Participants Last post by secretsquirl00, Dec 31, 2011

secretsquirl00

Discussion Starter · Dec 31, 2011

Does anyone have a better decription on how to install the Ait Intake Adapter. In particular, which was does the part that attaches to the motor go. It comes packaged fitting together but the instructions show it attaching looking like the side with the figure 8 groove pointing out. In the pictures on the website, one shows it facing out the other shows it facing in. The hose looks like it would attach easily if the side with the grooves faces the motor. If that sides faces out how does the hose attach?

Save

1 - 1 of 3 Posts

Natedog

· #2 · Dec 31, 2011

The smaller piece that fits inside the larger piece is what attaches to the bike. The side with the grooves for the o-rings is the side that makes contact with the bike. The smooth side fits into the larger (outer cover).

This is not an easy bolt-on installation. I had to make numerous adjustments and modifications to get mine to work. Fortunately once its on, there's little reason to ever remove it.

Hope that helps

Save

1 - 1 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month