[RockrideBob]

Probably a silly question.
Just got my mustang tank bib (with pouch) from west end. I was expecting tape or Velcro to hold in place but there are two long cord straps at each end that are just loops. I haven't pulled anything off yet, but what do they attach to? Do I need to remove the tank to hook straps in? Figured it would be quickest mod yet but has me going hmm?

 

[11Stryker]

Take the front one and pull back toward seat over top of tank. Rear one is a little tougher. Have to go under seat Latch on bike and wrap around that twice. Will get pics of my Son's for you tomorrow.

 

[RockrideBob]

Cool. Thanks

 

[BillyD66]

Probably a silly question.
Just got my mustang tank bib (with pouch) from west end. I was expecting tape or Velcro to hold in place but there are two long cord straps at each end that are just loops. I haven't pulled anything off yet, but what do they attach to? Do I need to remove the tank to hook straps in? Figured it would be quickest mod yet but has me going hmm?

Don't worry I actually called their customer service which I'm sure left them saying "dumbass..."
Take the seat off first. Then wrap one side under the gas tank and around the metal part under the seat that holds the seat release etc. It'll be easier and make more sense once you do it trust me! Then the other side does basically the same thing and ends up at the same place. After all is installed adjust as necessary to cover the gas tank surround equally.
Re-install the seat and things are all held in place fine. Trust me it'll all be a lot more clear once you start installing. If not give them a call since I'm sure we aren't the only 2 people to have called them on this

 

[female_stryker2012]

I didn't take my seat off at all. Mine holds just fine and looks good with a snug fit. I secured mine under the gas tank.