Hey my name is Nick and I recently purchased a new stryker. I live in Northeastern ohio, and have only gotten to put on 230 miles on the bike so far this year but I love it! Don't like how quiet it is stock so I drilled the baffles a little bit and it helped a little but I would like to make it louder. Saving up for my wedding next april so that puts a little bit of a damper on getting a new exhaust right away. Im not afraid of a little work so I guess what im getting at is how hard is it to remove the baffles? I have seen several different routes of doing it and was just curious with your guys experience in what you did to do it, also was curious how the bike ran with them out. If anyone has any information on this for me it will be greatly appreciated and hopefully others live in my area and we could meet up some time!
New to the forum
1 - 19 of 19 Posts
Joined
·
321 Posts
Welcome to the forum from Buffalo NY. I drilled 4
1/2 inch holes in each baffle and really like the sound. Enjoy your Stryker!
Sent from my SCH-S950C using Tapatalk 2
1/2 inch holes in each baffle and really like the sound. Enjoy your Stryker!
Sent from my SCH-S950C using Tapatalk 2
Joined
·
4,199 Posts
Welcome from Atlanta, ga
Joined
·
1,428 Posts
Hi, Nick! Like what Quantum said: drill the mufflers first and see if you like it before removing the baffles.
Joined
·
775 Posts
Welcome from Northeast PA
I did drill the baffles, did that right after I got it home, it helped a lot but I still wish it had a deeper sound. My old bike (02 vstar classic) had a full vance n hines exhaust on it. Obviously im not expecting that removing my baffles will make it sound the same. Its just hard to go from a bike that was that loud to go to a very quiet one
Joined
·
247 Posts
Welcome from Maryland
Joined
·
1,226 Posts
Welcome from So Cal.
1 - 19 of 19 Posts
