[chuckles]

I'm trying to open up the headlight to wire the passing lamps, and cannot get it to budge. There is just the 2 side bolts, right? What am I missing?

 

[Axorr]

It's just the two screws, but there is a bit of a metal lip / flange that helps keep it tight. Pull hard - but be prepared for it to pop off. Since you've not done it before, place a couple layers of towels over your front fender in case you drop the headlight front when it comes off.

 

[chuckles]

Thanks Axorr, I was thinking maybe I wasn't pulling hard enough, but was afraid I'd break something if that wasn't the case.

 

[Axorr]

Just watch it - when it does come off, you'll need to stop quickly. The wires are not very long in there!

 

[ROADKILL]

The Raider headlight has a lip at the top - so you have to pull on the bottom to get it off...not sure it the Stryker is the same.

 

[chuckles]

The bottom did start to come off first, so I got a little plastic scoop, with a straight edge, and worked it around the gap, slowly increasing the spread. When I got it all apart and unplugged, I couldn't find my diagonals to snip the ties on the old turn signals, so had to run to parts store. Thanks for the help, guys.
chuckles