rearend crap cutout

Thanks schimbo

hey Pete, I used the factory plate bracket, what we did was dremel the plastic off and then used a marker to mark the plate and then removed it and cut it. Leaving the plate on kept the plastic from moving while we cut it so we got a nice clean cut of the plastic and it required very little sanding to take away rough edges. It's a slow and tedious project but we still knocked it out in less than 2 hours. Thanks for the feedback. I'm not the 1st to do this by no means, just copying what others had done.

yeah, my son and i did it together, he rides sport bikes and all those guys do it

We cut the plastic off with it still on the bike, then we marked the plate, removed it and cut it. There is a wire that goes to the bottom light. You will have to cut it and wrap the end with electrical tape.