Yamaha Star Stryker banner

ScootMods forward controls

10416 Views 45 Replies 19 Participants Last post by  scootmods
I have kept my eye out for a forward controls kit for a while now, and recently learned that ScootMods was in the process of making one. They stated that their kit would not require moving or replacing the brake line, which was a big factor in my purchase. I spoke with them over the phone and via pm's, and they were friendly and kept me up to date on their progress. Fast forward a couple of weeks, and the kit was ready and is finally here. Upon opening the box I found each part meticulously wrapped in bubble wrap and packed well enough that nothing could move or get scratched up. There was also a full page of step by step instructions that were easy enough for me to follow. I laid the parts out to inspect them and snapped a few pictures of the kit. I also learned that photography is not my strong point lol.

Everything looked good and the finish was nice.


A couple more from a different angle.





Here are some before and after pictures




Notice in the after picture the master cylinder is still in its original position.




And finally an overall shot of both sides.




I am very satisfied with this kit, and am really enjoying how much more comfortable this made my ride.
See less See more
9
1 - 8 of 46 Posts
Thx, I'm still saving for my paint job this winter. I wish my hypercharger would have showed up today so it could have gotten in the picture lol.
Bozzly said:
Nice job. What color are you planning to paint her?
Ford's race red.
I'm not sure about a part number as I ordered mine over the phone. I would give them a call or pm them on here.
Phone # I called was 270-315-6535. The instructions that came with the kit listed their email as [email protected]
I forwarded the link to this post to them as well.
Double the price of what?
ApacheStryke said:
Ok - for the slightly less intelligent - The forward controls are a separate kit from the actual shifter? I.e. - you purchased the forward control kit and then a set of controls???

I really like your setup - just trying to figure out exactly what to buy :) and how would they work with floor boards??
The kit moves the footpeg assembly forward about 3" so you can stretch your legs out a bit more. Everything you need comes with the kit. Its a much more comfortable riding position depending on the length of your legs of course.
strykeraf said:
Does the install require any special tools??
No. A couple of sockets and a wrench or two is about the extent of it.
1 - 8 of 46 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top