[headeast]

Has anyone changed out the stock flasher relay for one that will handle LED's? I want to do that instead of the resisters or the load equalizers to slow the flash rate. I see they offer a 2 wire flasher, but the stryker relay has 5 pins, and I don't know if it can be adapted. If so, which one did you get and how did you wire it. Thanks in advance.

 

[rodekill]

I'm curious about this as well. I'm about to be all led and have been wondering the same thing.

 

[strykenshane]

Chromeglow has everything ya need and the install is pretty straight and easy

 

[rodekill]

Would you happen to have a link to the page or the part number for the relay?

 

[strykenshane]

Probably best to call customer service and see what they suggest, Chromeglow.com

 

[strykenshane]

I got the flexible wraps for the front and the L&M fender for the rear, Chromeglow made everything I needed, very idiot friendly

 

[SmokenJoe]

http://www.customled.com/products/flasher_relay/flasher_relay.htm#LayoutRegion1LYR

http://www.customdynamics.com/trick_flasher.htm#Standard_DOT_Flasher

This is the one I used on my VTX. That was a 3 wire set up. Stryker also has self canceling too. Not sure that would still work.??????????
http://motorcycle-accessories.cruis...part/BBP-13-306&rk=1&rsc=amZlFKJ-DMx0y0si&p=R

 

[headeast]

If I go with the dual load equalizer, will I need 1 or 2 to handle all four turn signals. I'd rather go with the relay but not sure if its possible to do with a 2 or 3 wire flasher relay as mentioned above.

 

[sfcmcgan]

I thought Chromeglow says only 1 equalizer is requires for all 4 turns. I will have to look it up.

 

[SmokenJoe]

I think only one is needed. But call to make sure.
(954) 341-6640

 

[headeast]

Closed today and tomorrow, I'll call on Monday. thanks.