[jmwinf146]

Cobra Slip-on sounds much better than stock. Was getting a lot of popping even with stock intake.

Cobra Powrflow intake. Well it was popping anyway. Now you can hear him breath. Exhaust got deeper tone too.

EJK tuner. No more popping. Well a little but I'm riding hard. I'm still playing/tuning and mileage yet to be determined. So far money well spent.

Sent from my LG-MS840 using Tapatalk 2

 

[ffemt89]

Did you install the EJK yourself?

 

[jmwinf146]

Yes all 3 were very easy to install. EJK tuner is ground wire and the injector plugs.

Sent from my LG-MS840 using Tapatalk 2

 

[ffemt89]

I put my VH twin slash on yesterday and may try and tackle the EJK tomorrow and the powerflo monday...i guess we'll see how it goes

 

[jmwinf146]

I think it took 3 hours doing the tuner and intake. Most of that was scratching my head debating to take the tank off or not. It's simple I was being lazy. =)

Sent from my LG-MS840 using Tapatalk 2

 

[mikey76]

I was able to unbolt the tank and just lift it slightly to route the wires for the tuner. Didnt have to remove the tank. Worst part was disconnecting the injector plugs.

 

[11Stryker]

Nice job- Now shorten the Slip-on and see more of that rear wheel! http://www.yamahastarstryker.com/18-mods-accessories/4465-modified-slip.html

 

[wayne]

I put my VH twin slash on yesterday and may try and tackle the EJK tomorrow and the powerflo monday...i guess we'll see how it goes

Have a look at this post. http://www.yamahastarstryker.com/20-how-tos/11097-cobra-auto-tuner-install-easy-way.html. When you pull of the air intake to install the power flow pop off one side of the equalizer hose on the throttle bodies and you have easy access to the injector plugs. Makes the tuner install a breeze.

 

[ffemt89]

You all are full of useful tips, I'll let ya know if I get to it tomorrow or not.

 

[ffemt89]

Thanks to all your awesome advice I got the powerflow and the EJK on today in about 3 hours, probably would have taken less time but I'm nowhere near mechanically inclined haha

 

[wayne]

Thanks to all your awesome advice I got the powerflow and the EJK on today in about 3 hours, probably would have taken less time but I'm nowhere near mechanically inclined haha

Not bad for a 1 hour job! Just kidding, glad it went well.

 

[ffemt89]

Haha thanks, one of these days I'll get something done in the amount of time its actually supposed to take