Yamaha Star Stryker banner
1 - 16 of 16 Posts

· Registered
Joined
·
265 Posts
Discussion Starter · #1 ·
Ok so I put the twin staggered, cobra air intake, cobra auto tune on my bike and they were working great for about 100 miles. I filled up with gas on Sunday and Tuesday morning I started getting low speed chugging almost dieing in 1st and 2nd. It only does it when I'm taking off slow and not gassing it. Checked the autotune and it has a solid red light showing its working... I read quite a few threads on this but is there a answer to this problem?
 

· Moderator
Joined
·
8,695 Posts
Make sure you are only using 86 or 87 octane. Also you may have gotten a bad tank of gas at station(Water). Try some seafoam and fuel up at different station next time. Hope this helps.
 

· Registered
Joined
·
1,918 Posts
Michael - did that fix your problem?

I just picked up my bike the other day - and I have the cobra power flo air intake, the cobra auto tuner and the V&H twin slash pipes...

I noticed that I get a bit of hesitation only at about 32-36 mph... that's it... can't figure that one out.... otherwise she runs like a dream.
 

· Moderator
Joined
·
8,695 Posts
I think you will be good with that mike and I occasionally use seafoam also. I have non-ethanol gas just 2 blocks away that I use. 4.38 a gallon though.
 

· Registered
Joined
·
6,785 Posts
Yesterday I had to use regular, my light came on and I was in the middle of nowhere. I was lucky the gas station had gas! They only had regular I put 6 bucks in, I knew I would find some good stuff further on down the road I just had to get there. Well, with regular my bike wanted to die at the light and started chugging. I was having bad thoughts but I remembered what I had just done.
 

· Moderator
Joined
·
8,695 Posts
Mikoloe may have gotten some bad gas (water). Happens a lot.
 

· Moderator
Joined
·
8,695 Posts
Tag under seat and my manual says 86 Octane
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top